RAID Recovery™ Guide in Pictures
Launch the executable file you downloaded.
When an installation is done you can start the restoration of your data.
The software is easy to use and does not require any additional skills.
To recover data on RAID you need to unRAID it and plug disks directly to your PC. This allows our software to access information blocked by RAID controller and allows actual RAID reconstruction.
Please disconnect disks from your RAID controller and connect them directly to your motherboard. If you don't have necessary interface or number of ports, you can try using your RAID controller as an interface card(if there is such setting) or create disk images from array's disks and mount them to free necessary ports.
Use RAID Wizard to start reconstruction process and follow it's guide entering known RAID parameters.
After recovering RAID data is finished a new disk\disks will be added to the disk list and marked red. It's advised to open one using Reader mode to estimate if RAID reconstruction was successful by previewing some pictures with size more then 1-2Mb. If you see a picture as damaged you need to recheck RAID parameters at RAID Wizard.